In menu mode, press to navigate through menu. Press to skip to next song, press and hold to skip to next folder. In menu mode, press to navigate through menu. 10 )K 2 Getting started Install 1 Insert the CD supplied with your product into the CD ROM drive of your PC. 2 Follow the onscreen instructions to complete the installation of the Firmware manager and if required, device drivers. 3 If the installation program does not start automatically, browse the CD contents via Windows Explorer and run the program by double clicking on the file ending with. Windows 98SE user: To avoid installation problems, do not connect your device to the computer until after installation completes. Lost your CD? Don't worry, you can download the CD contents from www. philips. com/support or www. philips. com/usasupport (for U. residents). Connect Insert the battery 1 Remove the USB cap. 2 Remove the battery door by sliding it in the direction of arrow. 3 Insert the supplied AAA battery into the battery compartment. Read the battery level indication of your player The approximate power levels of your battery are indicated as follows: Full Two-thirds full Half full Low Empty TIP When the batteries are nearly empty, the battery low screen blinks. Your player will power down in less than 60 seconds. Your player will save all settings and un-finished recordings before it powers down. 3 EN Transfer Your player appears as a USB mass storage in Windows Explorer...